If the issue you’re having is that your Whirlpool prime load washer will not spin dry the garments, observe this process to find out if the issue is a damaged motor coupler.
Set the washer on the common cycle, massive load and let it fill. After the washer fills to the chosen degree, the motor ought to begin and the agitator ought to begin agitating.
In the event you hear the motor operating whirlpool washer repair los angeles, however the agitator would not transfer in any respect, do the next. Cease the washer and set the timer on the spin cycle and let it run.
If the washer motor runs and the washer empties the water from the tank, however it will not spin, that is a sign that the motor coupler isn’t turning the transmission in any respect.
The motor coupler is made from two items of plastic referred to as fingers and a tough rubber piece that goes in between the 2 fingers. One of many fingers is hooked up to the motor and the opposite finger is hooked up to the transmission. The had rubber spherical piece goes between the 2 fingers. When one of many plastic fingers breaks, the motor is now not coupled to the transmission and the washer is not going to agitate or spin dry the garments. The explanation that the motor coupler breaks earlier than it ought to, it’s that the person overloads the washer. Folks stuff the washer with an excessive amount of garments, large comforters, small placer rugs, snickers, and many others.
One more reason is that the washer is used each day; usually the washer is used three occasions per week. So when you’ve got a washer that’s 5 years previous and you utilize it each day, it has the wear and tear and tear of a washer that’s 10 years previous.
Changing the motor coupler isn’t laborious to do, when you see how the restore is completed. You’ll save at the least $100 by changing the motor coupler your self.
I hope this this info has been of assist to you in figuring out if the motor coupler is the issue when your Whirlpool prime load washer isn’t spinning the garments dry.